CISCO 6509 核心交换机 WS-C6509-1300AC= Catalyst 6509 Chassis w/ 1300W AC Power Supply 冗余电源 WS-CAC-1300W/2 Catalyst 6000 Second 1300W AC Power Supply 交换机引擎 WS-X6K-S2-MSFC2 Catalyst 6500 Supervisor Engine-2, 2GE, plus MSFC-2 / PFC-2 冗余交换引擎 WS-X6K-S2-MSFC2/2 Catalyst 6500 Red. Sup2, 2GE, MSFC2 and PFC2 (In Chassis Only) 背板扩展模块 WS-C6500-SFM Catalyst 6500 Switch Fabric Module 电口模块 WS-X6316-GE-TX Catalyst 6000 16-port 1000TX GE Mod., RJ-45 光纤口模块 WS-X6408A-GBIC Catalyst 6000 8-port GE, Enhanced QoS (Req. GBICs) 1000BASE-ZX口(单模) WS-G5487 1000Base-ZX extended reach GBIC(singlemode) 1000BASE-LX/LH口(单模) WS-G5486 1000BASE-LX/LH long haul GBIC (singlemode or multimode)
Jac6509-sup #! #vtp set vtp domain jac set vtp passwd jac set vlan 1 name default type ethernet mtu 1500 said 100001 state active set vlan 2 name pub type ethernet mtu 1500 said 100002 state active set vlan 3 name mgr type ethernet mtu 1500 said 100003 state active set vlan 4 name tec type ethernet mtu 1500 said 100004 state active set vlan 5 name test type ethernet mtu 1500 said 100005 state active set vlan 1002 name fddi-default type fddi mtu 1500 said 101002 state active set vlan 1004 name fddinet-default type fddinet mtu 1500 said 101004 state active stp ieee set vlan 1005 name trnet-default type trbrf mtu 1500 said 101005 state active stp ibm set vlan 1003 name token-ring-default type trcrf mtu 1500 said 101003 state active mode srb aremaxhop 7 stemaxhop 7 backupcrf off ! #ntp set timezone PDT -7 0 ! #set boot command set boot config-register 0x2 set boot system Flash bootflash:cat6000-sup2k8.7-3-1.bin ! # default port status is enable ! ! #module 1 : 2-port 1000BaseX Supervisor ! #module 2 : 2-port 1000BaseX Supervisor ! #module 3 : 8-port 1000BaseX Ethernet ! #module 4 : 16-port 1000BaseT Ethernet set vlan 2 4/1-4 ! #module 5 : 0-port Switch Fabric Module ! #module 6 empty ! #module 7 empty ! #module 8 empty ! #module 9 empty ! #module 15 : 1-port Multilayer Switch Feature Card ! #module 16 : 1-port Multilayer Switch Feature Card end
jac 6509-msfc interface Vlan2 ip address 192.168.9.252 255.255.255.0 no ip redirects standby ip 192.168.9.254 ! interface Vlan3 ip address 10.1.255.253 255.255.0.0 ip access-group mgr in no ip redirects standby ip 10.1.255.254 ! interface Vlan4 ip address 10.2.255.253 255.255.0.0 ip access-group tec in no ip redirects standby ip 10.2.255.254 ! ip classless no ip http server ! ! ip access-list extended mgr permit ip 10.1.0.0 0.0.255.255 10.1.0.0 0.0.255.255 deny ip 10.1.0.0 0.0.255.255 10.0.0.0 0.255.255.255 permit ip 10.1.0.0 0.0.255.255 any ip access-list extended tec permit ip 10.2.0.0 0.0.255.255 10.2.0.0 0.0.255.255 deny ip 10.2.0.0 0.0.255.255 10.0.0.0 0.255.255.255 permit ip 10.2.0.0 0.0.255.255 any ! !
