信道化E1 简单配置

2019-11-04 20:38:39

字体：大中小

来源：转载

供稿：网友

　　Router# configure terminal
　　Router(config)# controller e1 1/1/0
　　Router(config-controll)# channel-group 20 timeslot 1-5, 20-23
　　Router(config-controll)# channel-group 21 timeslot 6-19
　　Router(config-controll)# interface serial 1/1/0:20
　　Router(config-if)# ip address 10.20.30.1 255.255.255.0
　　Router(config-if)# interface serial 1/1/0:21
　　Router(config-if)# ip address 10.20.40.1 255.255.255.0
　　
　　Router# show interface serial 3/0:30
　　Serial3/0:30 is up, line PRotocol is up (looped)
　　Hardware is Multichannel E1
　　MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec, rely 255/255, load 1/255
　　Encapsulation HDLC, CRC 16, Data non-inverted, keepalive set (10 sec)
　　Last input 00:00:08, output 00:00:08, output hang never
　　Last clearing of “show interface” counters 00:00:27
　　Input queue: 0/75/0 (size/max/drops); Total output drops: 0
　　Queueing strategy: weighted fair
　　Output queue: 0/64/0 (size/threshold/drops)
　　Conversations 0/1 (active/max active)
　　Reserved Conversations 0/0 (allocated/max allocated)
　　5 minute input rate 0 bits/sec, 0 packets/sec
　　5 minute output rate 0 bits/sec, 0 packets/sec
　　2 packets input, 48 bytes, 0 no buffer
　　Received 0 broadcasts, 0 runts, 0 giants
　　0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
　　2 packets output, 48 bytes, 0 underruns
　　0 output errors, 0 collisions, 0 interface resets
　　0 output buffers copied, 0 interrupts, 0 failures
　　0 carrier transitions
　　no alarm present
　　Timeslot(s) Used:31, subrate: 64Kb/s, transmit delay is 0 flags
　　
　　这是打环测试
　　信道化E1 简单配置