centos 6.8命令行下使用pptpsetup进行pptp拨号的实现方法

2024-09-01 13:48:17

字体：大中小

来源：转载

供稿：网友

centos 6.8 命令行下可使用pptpsetup进行pptp拨号

1.先安装ppp，pptp和pptp-setup三个包

yum install -y ppp pptp pptp-setup

2.使用pptpsetup进行连接

pptpsetup --create VPN名字 --server 服务器IP --username 用户名 --password 密码 --encrypt --start [root@centos6-8-1 ~]# pptpsetup --create vpn --server 192.168.127.128 --username user --password passwd --encrypt --startUsing interface ppp0Connect: ppp0 <--> /dev/pts/2CHAP authentication succeededMPPE 128-bit stateless compression enabledlocal IP address 192.168.0.235remote IP address 192.168.0.1

使用ip addr可以看到多了一个接口ppp0:

[root@centos6-8-1 ~]# ip addr

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN

link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00inet 127.0.0.1/8 scope host loinet6 ::1/128 scope host valid_lft forever preferred_lft forever

2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP qlen 1000

link/ether 00:0c:29:27:eb:e7 brd ff:ff:ff:ff:ff:ffinet 192.168.127.129/24 brd 192.168.127.255 scope global eth0inet6 fe80::20c:29ff:fe27:ebe7/64 scope link valid_lft forever preferred_lft forever4: ppp0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1496 qdisc pfifo_fast state UNKNOWN qlen 3link/ppp inet 192.168.0.235 peer 192.168.0.1/32 scope global ppp0

3.添加默认路由